Description

3.52inch E-Paper HAT for Raspberry Pi (360×240)

This 3.52″ e-Paper HAT is a tri-colour display with no backlight, and retains the last displayed image for long periods even when powered off, making it very energy-efficient. Power is only needed during refreshes, meaning power consumption is at a minimal level. The display also has a wide 170?? viewing angle for clear visibility from different areas of viewing.

It has a standard Raspberry Pi 40-pin GPIO extension header, making it compatible with Raspberry Pi series boards, Jetson Nano, and RDK X3. The SPI connection allows it to work with other controller boards like Arduino and STM32, while a built-in voltage translator provides compatibility with both 3.3V and 5V MCUs. Included online development resources and a manual, make things easy to get started!

If you’re looking for the Raw display version, click here to find it in our store.

Features

  • No backlight, keeps displaying last content for a long time even when powered down
  • Ultra-low power consumption, basically power is only required for refreshing
  • Comes with online development resources and manual (driver board circuit diagram, examples for Raspberry Pi / Jetson Series / RDK X3 / Arduino / STM32)
  • Standard Raspberry Pi 40-pin GPIO extension header, supports Raspberry Pi series boards, Jetson Nano, RDK X3
  • Compatible with Raspberry Pi 5 / 4B / 3B / 3B+
  • SPI interface for connecting with controller boards like Arduino / STM32, etc.
  • Voltage translator, compatible with 3.3V / 5V MCUs

Specifications

Operating Voltage 3.V/5V
Interface 3-wire SPI, 4-wire SPI
Outline Dimensions 86.50 x 57.00 (mm)
Display Size 74.51 x 49.67 (mm)
Dot Pitch 0.207 x 0.207 (mm)
Resolution 360 x 240 pixels
Display Colour Red/Black/White
Grey Scale 2
Full Refresh Time 16s
Refresh Power <25mW
Standby Current <0.01uA (almost none)
Viewing Angle >170??

Connection Example – Raspberry Pi

Note: Raspberry Pi is NOT included

Resources

  • Product Wiki
  • Schematic

Pinout

VCC Power (3.3V / 5V input)
GND Ground
DIN SPI MOSI pin
CLK SPI SCK pin
CS SPI chip selection, low active
DC Data/Command selection (high for data, low for command)
RST External reset, low active
BUSY Busy status output pin

Package Contents

  • 1x 3.52″ e-Paper HAT
  • 1x PH2.0 8-pin Cable
  • 1x Screws Pack