Description

4.26inch E-Paper Display HAT (800×480)

This 4.26″ display HAT has a high resolution of 800 x 480 in black and white with a greyscale level of 4, providing clear and sharp images. It has a wide viewing angle of 170?? and does not require a backlight, allowing it to continue showing the last content for an extended period even after the power has been turned off. It is made for ultra-low power consumption, only requiring power during refresh phases.

This display HAT includes a standard Raspberry Pi 40-pin GPIO extension header, making it compatible with various Raspberry Pi series boards. It also features an SPI interface for easy connection with other controller boards like the Raspberry Pi, Jetson Nano, Arduino, and STM32.?

Note: Raspberry Pi is NOT included

Features

  • No backlight, keeps displaying last content for a long time even when powered down
  • Ultra-low power consumption, basically power is only required for refreshing
  • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards
  • SPI interface, for connecting with other controller boards like Raspberry Pi/Jetson Nano/Arduino/STM32, etc.
  • Onboard voltage translator, compatible with 3.3V/5V MCUs
  • Comes with online development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Specifications

Operating Voltage 3.3V/5V
Interface 3-wire SPI, 4-wire SPI
Outline Dimensions 107 x 64mm
Display Size 92.80 x 55.68mm
Dot Pitch

0.116x 0.116mm
Viewing Angle >170??
Resolution 800 x 480 pixels
Display Colour Black/White
Grey Scale 4
Full Refresh Time 4s
Partial Refresh Time 0.7s
Refresh Power <35mW
Standby Current <0.01uA (almost none)

Resources

  • Product Wiki
  • Schematic
  • User Manual

Pinout

PWR Power on/off control
BUSY Busy status output pin
RST External reset, low active
DC Data/Command selection (high for data, low for command)
CS SPI chip selection, low active
CLK SPI SCK pin
DIN SPI MOSI pin
GND Ground
VCC Power (3.3V / 5V input)

Package Contents

  • 1x 4.26″ e-Paper HAT
  • 1x GH1.25 9-pin cable 20cm
  • 1x Screws pack